Owner's Manual
40
First Time Setup
—Continued
If you connect a video component to a COMPONENT
VIDEO IN, you must assign that input to an input
selector. For example, if you connect your DVD player
to COMPONENT VIDEO IN 2, you must assign COM-
PONENT VIDEO IN 2 to the DVD input selector.
By default, the DVD input selector is assigned to COM-
PONENT VIDEO IN 1, and all of the other input selec-
tors (VCR/DVR, CBL/SAT, Game/TV, Tape, CD) are
assigned to the “- - -” option.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
If you connect a component to a digital audio input, you
must assign that input to an input selector. For example,
if you connect your CD player to OPTICAL IN 1, you
must assign OPTICAL IN 1 to the CD input selector.
These are the default assignments.
Component Video Input Setup
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Input
Assign,” and then press [Enter].
3
Use the Up and Down [ ]/[ ]
buttons to select “1-2. Compo-
nent,” and then press [Enter].
Setup
Receiver
Enter
4
Use the Up and Down [ ]/[ ]
buttons to select an input selec-
tor, and use the Left and Right
[ ]/[ ] buttons to select:
IN1:
Select if the video compo-
nent is connected to COM-
PONENT VIDEO IN 1.
IN2:
Select if the video compo-
nent is connected to COM-
PONENT VIDEO IN 2.
- - - - -:
Select if you’re not using the
COMPONENT VIDEO IN1
or IN2.
5
Press the [Setup] button.
Setup closes.
Digital Input Setup
Input selector Audio input
DVD COAX1
VCR/DVR - - -
CBL/SAT COAX2
Game/TV OPT1
Tape - - -
CD OPT2
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
DTR-4.9_En.book Page 40 Tuesday, April 15, 2008 5:13 PM