Owner's Manual

66
Zone 2
In addition to your main listening room, you can also enjoy playback in the other room, or as we call Zone 2. And, you
can select a different source for each room.
Connecting Your Zone 2 Speakers to an
Amp in Zone 2
This setup allows 5.1-channel playback in your main lis-
tening room and 2-channel stereo playback in Zone 2,
with a different source in each room.
Hookup
• Use an RCA audio cable to connect the AV receiver’s
ZONE 2 PRE OUT L/R jacks to an analog audio input
on your Zone 2 amp.
• Connect your Zone 2 speakers to the speaker termi-
nals on your Zone 2 amp.
Notes:
• The Zone 2 volume must be set on the Zone 2 amp.
• If you’re using a power amp with no volume control in
Zone 2, you must set the Zone 2 Out setting to Variable
(see right column).
If you’ve connected your Zone 2 speakers to an amp with
no volume control, set the Zone 2 Out setting, respec-
tively, to Variable so that you can set the zone’s volume,
balance, and tone on the AV receiver.
Connecting Zone 2
R
L
IN
R
L
ZONE 2
PRE OUT
Main room
Zone 2
TV
Receiver/
integrated amp
AV receiver
Zone 2 Out Settings
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [Enter].
3
Use the Up and Down [ ]/[ ]
buttons to select “Zone 2” and
then press [Enter].
4
Use the Up and Down [ ]/[ ]
buttons to select “Z2 Out” and
use the Left and Right [ ]/[ ]
buttons to select:
Fixed: The Zone 2 volume must be
set on the amp in that zone.
Variable: The Zone 2 volume can be
set on the AV receiver.
Setup
Receiver
Zone2
Enter
Input
Selector
On/Standby
DTR-4.9_En.book Page 66 Tuesday, April 15, 2008 5:13 PM