Owner's Manual

67
Zone 2 —Continued
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
Notes:
• Only analog input sources are output by Zone 2. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check to make sure
it’s connected to an analog input.
• While Zone 2 is on, the Auto Power On/Standby and
Direct Change functions do not work.
Controlling Zone 2 with the Remote
Controller
5
Press the [Setup] button.
Setup closes.
Using Zone 2
1
To turn on Zone 2 and select an
input source, press the [Zone 2]
button repeatedly.
Alternatively, press the [Zone 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on and ZONE 2 indicator
lights up.
To select the same source as that of the
main room, press the [Zone 2] button
repeatedly until “Z2 Sel: Source”
appears.
To select AM or FM press the [Tuner]
Input Selector button repeatedly.
Note:
•You cannot select different AM or
FM radio stations for your main
room, Zone 2. The same AM/FM
radio station will be heard in each
room.
Zone 2
Off
2
To turn off Zone 2, press the
Zone 2 [Off] button.
1
Press the [Zone 2] button, then
point the remote controller at the
AV receiver and press the
[On/Standby] button.
Zone 2 turns on and ZONE 2 indicator
lights up.
2
To select an input source for
Zone 2, press the [Zone 2] button,
followed by an Input Selector but-
ton.
To select AM or FM press the [Tuner]
Input Selector button repeatedly.
Note:
•You cannot select different AM or FM
radio stations for your main room,
Zone 2. The same AM/FM radio sta-
tion will be heard in each room.
3
To turn off Zone 2, press the
[Zone 2] button, followed by the
[On/Standby] button.
DTR-4.9_En.book Page 67 Tuesday, April 15, 2008 5:13 PM