Owner's Manual

65
En
Zone 2 Video Output
The AV receiver features a composite video output for con-
nection to a TV in Zone 2, so you can enjoy both audio and
video in that zone.
Note
•The ZONE 2 OUT V jack outputs video from components con-
nected to composite video inputs.
■ Zone 2 Out
See “Zone 2 Out” in “Hardware Setup” (➔ page 58).
■ Zone 2 Maximum Volume
See “Zone 2 Maximum Volume” in “Hardware
Setup”(➔ page 58).
■ Zone 2 Power On Volume
See “Zone 2 Power On Volume” in “Hardware Setup”
(➔ page 58).
■ Operating on the AV receiver
■ Operating on the remote controller
To control Zone 2, you must press Zone2 on the remote
controller first.
Hookup
• Use a composite video cable to connect the AV receiver’s
ZONE 2 OUT V jack to a composite video input on your
Zone 2 TV.
Setting the Zone 2 Out
Main room
TV
Zone 2
AV receiver
TV
Controlling Zone 2 Components
1
To turn on Zone 2 and select an input source, press
Zone 2 followed by an input selector button within
8 seconds.
Zone 2 turns on, the Z2 indicator lights on the display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press the Tuner input selector
and Zone 2 repeatedly.
To select the same source as the main room’s, press
Zone 2 repeatedly until “Z2 Selector: Source”
appears on the display.
To turn off Zone 2, press Off.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
1
Press Zone2 and then press 8Receiver.
Zone 2 turns on, the Z2 indicator lights on the display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2, press Zone2,
followed by an input selector button.
To select AM or FM, press the Tuner input selector
and Zone2 repeatedly.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same AM/FM radio
station will be heard in each room.
Input selector buttons
Zone 2
Off
Zone 2 Level q/w
Tone
+, –
Input selector buttons
8Receiver
Zone2
Muting
VOL q/w