Owner's Manual

En-3
123 45 6 789F GH I
JK
L
MN
OP Q
R
(Australian models)
Front Panel
1 zOn/Standby button: Turns the unit on or into standby
mode�
2 Dolby Atmos indicator: Lights when playing Dolby
Atmos�
3 DTS:X indicator: Lights when playing DTS:X�
4 Tone and Tone Level buttons: Adjust the high tone
and low tone�
5 Remote control sensor: Receives signals from the
remote controller�
6 Display
7 Listening Mode buttons: Allow you to select the
listening mode�
8 Dimmer button (North American models): Switches
the brightness of the display�
RT/PTY/TP button (Australian models): Can be used
when receiving the station transmitting text information�
9 Memory button: Registers a station�
F Tuning Mode button: Switches the tuning mode�
G Display button: Switches the information on the
display�
H Setup button: Used when making settings�
I Cursor buttons, Tuning
jl
button, Preset
d c
button and Enter button: Move the cursor and
confirms the selection� When listening to AM/FM
broadcasting, tune in to the station with Tuning
jl
or
select the registered station with Preset
d c
�
J Return button: Returns the display to the previous
state�
K Master Volume: Allows you to adjust the volume�
L Zone 2 button and Off button: Controls the multi-zone
function�
M Zone 2 Level  /  button: Allows you to adjust the
speaker volume of a separate room�
N Phones jack: Stereo headphones with a standard plug
are connected�
O AUX Input HDMI jack: A HD camera or such other
device is connected�
P Hybrid Standby indicator: Lights if the unit enters
standby mode when the HDMI Standby Through, USB
Power Out at Standby or Network Standby function is
enabled�
Q Input selector buttons: Switch the input to be played�
R Setup Mic jack: The supplied speaker setup
microphone is connected�