Owner's Manual

Advanced Settings (Setup Menu)
En-55
7� Remote Controller
Setting Item Default Value Setting Details
Remote ID 1 Select an ID for the unit's remote controller from
"1", "2", and "3" to prevent interference between
the unit and other Integra/Onkyo components
that are installed in the same room� After
changing the ID on the main unit, change the
ID on the remote controller accordingly with the
following procedure�
1� While holding down RCV, press and hold
Setup for about 3 seconds until the remote
indicator lights�
2� With the number buttons, press one of 1, 2,
and 3� The remote indicator flashes twice�
Remote Mode – Input and register the remote controller code of
other devices�
● For registration of the remote control code,
refer to the next section, "Operating Other
Components with the Remote Controller"�
8� Miscellaneous
Firmware Update
Setting Item Default Value Setting Details
Update Notice Enable Availability of a firmware update will be notified
via network�
"Enable": Notify updates
"Disable": Do not notify updates
Version – The current firmware version will be displayed�
Update via NET – Press Enter to select when you want to update
the firmware via network�
● You will not be able to select this setting if
you do not have Internet access or there is
nothing to update�
Update via USB – Press Enter to select when you want to update
the firmware via USB�
● You will not be able to select this setting if
a USB storage device is not connected or
there is nothing to update in the USB storage
device�
● Wait for a while if "Firmware Update" cannot be selected� It will appear when the network function is
started up�
Initial Setup
You can make the initial setup from the setup menu�
● Wait for a while if "Initial Setup" cannot be selected� It will appear when the network
function is started up�
Lock
Setting Item Default Value Setting Details
Setup Parameter Unlocked Lock the Setup menu to protect the settings�
"Locked": The menu is locked�
"Unlocked": The menu is unlocked�