Owner's Manual

ManualsBrandsIntegra ManualsReceiversIntegra DTR-40.7

100

Advanced speaker connections

En-61

Advanced speaker connections

Connecting Bi-amp Speakers

It is possible to connect speakers supporting bi-amping to

improve quality of the bass and treble� Up to 5�1 ch will be

played in bi-amping�

¼ Connections

1� Connect as below using the FRONT terminals and

BACK or HEIGHT terminals�

Tweeter

(high pitched tone)

Woofer

(low pitched tone)

Front R Front L

2� Turn the unit on and make the bi-amping setting�

1 After pressing RCV on the remote controller, press

Setup�

2 With the cursors, select "2� Speaker" -

"Configuration" - "Bi-Amp"�

3 Select "Yes" with the cursors�

● Before bi-amping, be sure to remove the short-

circuit connector that connects the tweeter (treble)

jack and the subwoofer (bass) jack�

● Use speakers supporting bi-amping only� For

details, refer to the speakers' instruction manual�

Connecting Dipole Speakers

A dipole speaker is bidirectional speaker outputting the

same sound in two directions, for example forward and

backward�

¼ Connections

An arrow for matching the phases () is marked on a

dipole speaker� Place the surround speakers (a) so that

their arrows ( ) point to the TV and the back speakers (b)

so that their arrows ( ) point to each other�

¼½ Phase: If the phases do not match due to mistake in speaker distance,

installation angle or positive/negative of wiring, sound image and sound

field may be unclear or hard of listening�

Connecting a Power Amplifier

You can connect a power amplifier to the unit and use the

unit as a pre-amplifier in order to produce a large volume

that cannot be output with the unit only� Connect the

speakers to the power amplifier� For details, refer to the

power amplifier's instruction manual�

¼ Connections

1� Connect as below using the PRE OUT terminals�

Power amplifier

● Set to suit the number of speaker channels connected�

– After pressing the RCV button, press the Setup

button on the remote controller� Select "2� Speaker"

- "Configuration" - "Speaker Channels" in order with

the cursors, and set the number of speaker channels�