Owner's Manual

136
Multi Zone—Continued
Notes:
• Only analog input sources are output by the ZONE 2/
3 PRE OUT and ZONE 2/3 L/R speaker terminals.
Digital input sources are not output. If no sound is
heard when an input source is selected, check if it’s
connected to an analog input.
• You cannot select different AM or FM radio stations
for your main room and Zone 2/3. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• When you connect Zone 2 speakers directly to the AV
receiver, listening modes that require surround back
speakers or front high speakers or front wide speakers
(6.1/7.1), such as Dolby Digital EX, DTS-ES, THX
Select2 Cinema, Dolby Pro Logic IIz height or
Audyssey Dynamic Surround Expansion™ are
unavailable.
• When you connect Zone 3 speakers directly to the AV
receiver, listening modes that require surround speak-
ers are unavailable.
• When the input selector of Zone 2/3 is selected, power
consumption on standby mode slightly increases.
• While Zone 2/3 is on, u functions will not work.
Adjusting the Volume for Zones
Muting Zones
Adjusting the Tone and Balance of Zones
Notes:
• Zones can also be unmuted by adjusting the volume.
• The Zone 2 volume, tone, and balance function cannot
be set when the “Zone2 Out” setting is set to “Fixed”
and “Powered Zone2” setting is set to “Not Act”
(page 134).
• The Zone 3 volume, and balance function cannot be
set when the “Zone3 Out” setting is set to “Fixed” and
“Powered Zone3” setting is set to “Not Act”
(page 134).
• Even if you repeatedly press the remote controller’s
[Zone] button to select zones, the last zone selection
will be retained once you have switched to other com-
ponents by pressing other Remote Mode buttons after
pressing the [Zone] button.
Remote
controller
On the remote controller, press
the [Zone] button repeatedly, and
then use the VOL [q]/[w] button.
AV receiver
On the AV receiver, press the
[Zone 2] or [Zone 3] button, and
then press the Zone Level Down
and Up [w]/[q] buttons.
Remote
controller
On the remote controller, press
the [Zone] button repeatedly, and
then press the [Muting] button.
To unmute a zone, on the remote
controller, press the [Zone]
button, and then press the
[Muting] button again.
1
AV receiver
On the AV receiver, press the
[Zone 2] or [Zone 3] button.
2
Press the AV receiver’s [Tone]
button repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use the Down and Up [–]/[+]
buttons to adjust the bass, treble
or balance.
• You can boost or cut the bass or tre-
ble from –10 dB to +10 dB in 2 dB
steps.
• You can adjust the balance from 0 in
the center to +10 dB to the right or
+10 dB to the left in 2 dB steps.