Owner's Manual

96
Advanced Setup—Continued
Center
*2
Surround
*2*6
Front Wide
*2*3*5*6
Front High
*2*3*5*6
Surr Back
*3*4*5*6
Full Band, 40Hz, 45Hz, 50Hz, 55Hz, 60Hz, 70Hz, 80Hz(THX), 90Hz, 100Hz, 110Hz,
120Hz, 130Hz, 150Hz, 200Hz
None: Select if no speaker is connected.
Surr Back Ch
*7
1ch: Select if only one surround back L speaker is connected.
2ch: Select if two (left and right) surround back speakers are connected (default).
LPF of LFE (Low-Pass Filter for the LFE Channel)
80Hz(THX) (default), 90Hz, 100Hz, 110Hz, 120Hz
This setting is not set automatically by Audyssey MultEQ
®
Room Correction and Speaker Setup (see page 53).
With this setting, you can specify the cutoff frequency of the LFE channel’s low-pass filter (LPF), which can
be used to filter out unwanted hum. The LPF only applies to sources that use the LFE channel.
* If you’re using THX-certified speakers, select “80Hz(THX)”.
DoubleBass
*8
On: Double Bass function on (default).
Off (THX): Double Bass function off.
This setting is not set automatically by Audyssey MultEQ
®
Room Correction and Speaker Setup (see page 53).
With the Double Bass function, you can boost bass output by feeding bass sounds from the front left and right,
center channels to the subwoofer.
* If you’re using THX-certified speakers, select “Off(THX)”.
Notes:
*1 If the “Subwoofer” setting is set to “No”, the “Front” setting is fixed at “Full Band”.
*2 If the “Front” setting is set to anything other than “Full Band”, “Full Band” cannot be selected here.
*3 If the “Surround” setting is set to “None”, this setting cannot be selected.
*4 If the “Surround” setting is set to anything other than “Full Band”, “Full Band” cannot be selected here.
*5 If the “Speakers Type(Front)” setting is set to “ Bi-Amp ” ( page 50 ), or “Powered Zone2” is set to “Act” (page 133), this setting
cannot be selected.
*6 If the “Powered Zone3” setting is set to “Act” (page 133) this setting cannot be selected.
*7 If the “Surr Back” setting is set to “None”, this setting cannot be selected.
*8 This function can be set only if the “Subwoofer” setting is set to “Yes”, and the “Front” setting is set to “Full Band”.
Speaker Distance
This setting is set automatically by Audyssey MultEQ
®
Room Correction and Speaker Setup (see page 53).
Here you can specify the distance from each speaker to the listening position so that the sound from each speaker
arrives at the listener’s ears as the sound designer intended.
Unit feet: Distances can be set in feet. Range: 0.2 to 30 feet in 0.2-foot steps.
(North American models: default)
meters: Distances can be set in meters. Range: 0.06 to 9 meters in 0.06-meter steps.
(Australian models: default)
Left, Front Wide Left, Front High Left, Center, Front High Right, Front Wide Right, Right, Surr Right,
Surr Back Right, Surr Back Left, Surr Left, Subwoofer
Specify the distance from the each speaker to your listening position.
Note:
You cannot select speakers that you set to “No” or “None” in the “Speaker Configuration” (page 95).