Owner's Manual

29
En
Note
• Make the room as quiet as possible. Background noise and Radio
Frequency Interference (RFI) can disrupt the room measure-
ments. Close windows, televisions, radios, air conditioners, flu-
orescent lights, home appliances, light dimmers, or other
devices. Turn off the cell phone (even if it is not in use) or place
it away from all audio electronics.
• The microphone picks up test tones which played through each
speaker as Audyssey MultEQ
®
Room Correction and Speaker
Setup run.
• Audyssey MultEQ Room Correction and Speaker Setup cannot
be performed while a pair of headphones is connected.
1
Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV receiver
is connected.
2
Set the speaker setup microphone at the Main Lis-
tening Position a, and connect it to the Setup
Mic jack.
The speaker setting menu appears.
3
When you’ve finished making the settings, press
Enter.
• If your front speakers are bi-amped, you must
select “Bi-Amp” in the “Speakers Type(Front)”
setting (➔ 51). For hookup information, see “Bi-
amping the Front Speakers” (➔ 15).
• If you change “Powered Zone 2” setting, refer to
“Setting the Powered Zone 2” for more details
(➔ 79).
• If you are using a subwoofer(s), select “Yes ” in the
“Subwoofer” (➔ 51). If not, select “No” and skip
step 4.
TV
def
cab
: Listening area
a to f: Listening position
Speaker setup microphone
Setup Mic jack
MultEQ: Auto Setup
Speakers Type(Front)
Powered Zone 2
Subwoofer
Normal
Not Act
Yes
4
If you use a powered subwoofer(s), adjust the sub-
woofer volume level to 75dB.
Test tones are played through the subwoofer. Use the
volume control on the subwoofer.
Note
• If your subwoofer does not have a volume control, disre-
gard the level displayed and press Enter to proceed to the
next step.
• If you set the subwoofer’s volume control to its maximum
and the displayed level is lower than 75 dB, leave the sub-
woofer’s volume control at its maximum and press Enter
to proceed to the next step.
5
Press Enter.
Audyssey MultEQ Room Correction and Speaker
Setup starts.
Test tones are played through each speaker as
Audyssey MultEQ Room Correction and Speaker
Setup runs. This process takes a few minutes. Please
refrain from talking during measurements and do
not stand between speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey MultEQ Room Correction and
Speaker Setup, unless you want to cancel the setup.
6
Place the setup microphone at the next position,
and then press Enter.
Audyssey MultEQ performs more measurements.
This takes a few minutes.
7
When prompted, repeat step 6.
8
Use q/w to select an option, and then press Enter.
The options are:
` Save:
Save the calculated settings and exit
Audyssey MultEQ
Room Correction and Speaker
Setup
.
` Cancel:
Cancel Audyssey MultEQ Room Correction and
Speaker Setup
.
Note
• You can view the calculated settings for the speaker con-
figuration, speaker distances, and speaker levels by using
e/r.
9
Disconnect the speaker setup microphone.
TV
MultEQ: Auto Setup
Subwoofer Yes
Front 40Hz
Center 40Hz
Surround 100Hz
Front Wide None
Front High 100Hz
Surr Back 120Hz
Surr Back Ch 2ch
Save
Cancel
- - Review Speaker Configuration - -