Owner's Manual

79
En
If you’ve connected your Zone 2 speakers to the AV
receiver, as explained in “Connecting Your Zone 2 Speak-
ers Directly to the AV receiver” (➔ 77), you must set the
“Powered Zone 2” setting to “Act” (Activated).
Note
• Powered Zone 2 cannot be used if “Speakers Type(Front)” is
set to “Bi-Amp” (➔ 51).
• This procedure can also be performed on the AV receiver by
using Setup, arrows, and Enter.
Note
• This procedure can also be performed on the AV receiver by
using Setup, arrows, and Enter.
■ Zone 2 Out, Zone 3 Out
` Fixed
:
The Zone 2/3 volume must be set on the amp in that
zone.
` Variable:
The Zone 2/3 volume can be set on the AV receiver.
If you’ve connected your Zone 2/3 speakers to an amp
with no volume control, set the “Zone 2 Out” and“Zone 3
Out” setting, respectively, to “Variable” so that you can
set the volume, balance, and tone of Zone 2 and volume of
Zone 3 on the AV receiver.
■ Zone 2 Maximum Volume,
Zone 3 Maximum Volume
` Off
, 50 to 99 (Absolute display)
` Off
, –32dB to +17dB (Relative display)
With this setting, you can limit the maximum volume for
Zone 2/3.
Setting the Powered Zone 2
1
Press Receiver followed by Setup.
The main menu appears onscreen.
Tip
• If the main menu doesn’t appear, make sure the appropri-
ate external input is selected on your TV.
2
Use q/w to select “Speaker Setup”, and then press
Enter.
The “Speaker Setup” menu appears.
3
Use q/w to select “Speaker Settings”, and then
press Enter.
The “Speaker Settings” menu appears.
4
Use q/w to select “Powered Zone 2”, and use e/r
to select:
` Not Act:
Use FRONT WIDE/ZONE 2 L/R terminals to
connect front wide speakers. (Powered Zone 2
disabled.)
` Act:
Use FRONT WIDE/ZONE 2 L/R terminals to
connect Zone 2 speakers. (Powered Zone 2
enabled.)
5
Press Setup.
The setup menu closes.
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2–1. Speaker Settings
Speaker Impedance
Speakers Type(Front)
Powered Zone 2
6ohms
Normal
Not Act
Setting the Multi Zone
1
Press Receiver followed by Setup.
The main menu appears onscreen.
Tip
• If the main menu doesn’t appear, make sure the appropri-
ate external input is selected on your TV.
2
Use q/w to select “Hardware Setup”, and then
press Enter.
The “Hardware Setup” menu appears.
3
Use q/w to select “Multi Zone”, and then press
Enter.
The “Multi Zone” menu appears.
4
Use q/w to select an item, and use e/r to change
it.
The items are explained below.
5
Press Setup.
The setup menu closes.
7. Hardware Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Auto Power Down
6. Network
7. Firmware Update
7-2. Multi Zone
Zone 2 Out
Zone 2 Maximum Volume
Zone 2 Power On Volume
Zone 2 Component Out
Zone 3 Out
Zone 3 Maximum Volume
Zone 3 Power On Volume
Fixed
Off
Last
Use
Fixed
Off
Last