Owner's Manual

95
En
The AV receiver’s remote controller can learn the com-
mands of other remote controllers. By transmitting, for
example, the Play command from your CD player’s
remote controller, the remote controller can learn it, and
then transmit the exact same command when its 1 is
pressed in the CD remote mode.
This is useful when you’ve entered the appropriate remote
control code (➔ 91) but some buttons don’t work as
expected.
6
Press Enter.
A message for transfer will appear.
To use the remote controller, point it at the AV
receiver’s remote control sensor, as shown below.
7
Press Enter.
When the transfer is successful, the following screen
appears.
8
Press Enter.
The “Activities Setup” menu appears onscreen.
9
Press Setup.
The setup menu closes.
8–2. Activities Setup
My Movie
OK
Now we are ready to transfer data to the remote.
Please hold the remote so that it is facing the receiver.
Use ENTER button of your remote to activate “OK”.
Ready?
15
15
AV receiver
Approx.
16ft. (5 m)
Incoming sensor
Transmitter
15° off center
(Left/Right/Up/Down)
8–2. Activities Setup
My Movie
Wait...
8–2. Activities Setup
My Movie
Return
Successful
Learning Commands
1
While holding down Remote Mode for the mode
in which you want to use the command, press and
hold down On until Remote Mode button lights
(about 3 seconds).
2
On the supplied remote controller, press the but-
ton you want to learn the new command.
3
Point the remote controllers at each other, about 2
to 6 inches (5 to 15 cm) apart, and then press and
hold the button whose command you want to learn
until Remote Mode button flashes.
If the command is learned successfully, Remote
Mode button flashes twice.
4
To learn more commands, repeat steps 2 and 3.
Press any Remote Mode when you’ve finished.
Remote Mode button flashes twice.
On
Remote
Mode
DIMMER
SUR
MODE
C D
PHONO
MULTI-CH
INPUT
POWER
SLEEP
VIDEO-1
VIDEO-2
TAPEDVD
C D
DVD
TUNER
TUNER
INPUT SELECTOR
DISC
VOLUME
CH SEL
PRESET
UT
ING
TEST
TONE
GROUP
About 2 to 6 inches
(5 to 15 cm)
Supplied remote
controller