Owner's Manual

67
En
Zone 2 Video Output
The AV receiver features a composite video output for
connection to a TV in Zone 2, so you can enjoy both audio
and video in that zone.
Note
• If you use the COMPONENT VIDEO ZONE 2 OUT, you must
set the “Zone 2 Component Video Out” setting to “Yes”
(➔ page 60).
•The COMPONENT VIDEO ZONE 2 OUT outputs video only
from components connected to component video inputs.
•The ZONE 2 OUT V jack outputs video from components
connected to composite video inputs.
■ Operating on the AV receiver
■ Operating on the remote controller
To control Zone 2/3, you must press the remote
controller’s Zone first.
Zone turns red while Zone 2 is on, and green while
Zone 3 is on.
Note
• Zone 4 is not available for this model.
Controlling Zone 2/3 Components
Main room
Zone 2
TV
AV receiver
TV
or
Input selector buttons
Zone Level q/w
Zone 2, Off
Zone 3, Off
Tone
-, +
1
To turn on Zone 2/3 and select an input source,
press Zone 2 or Zone 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2/3 indicator lights on the
display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press Tuner input selector and
Zone 2 or Zone 3 repeatedly.
To select the same source as the main room’s, press
Zone 2 or Zone 3 twice. “Z2 Selector: Source” or
“Zone 3 Selector: Source” appears on the display.
To turn off Zone 2/3, press Zone 2 or Zone 3. The
Z2/3 indicator on the display flash. Press Off.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
1
Press Zone repeatedly, then point the remote
controller at the AV receiver and press 8Receiver.
Zone 2/3 turns on, the Z2/3 indicator lights on the
display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press Zone
repeatedly, followed by Input Selector.
To select AM or FM, press the Tuner input selector
and Zone repeatedly.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2/3. The same AM/FM radio
station will be heard in each room.
3
To turn off Zone 2/3, press Zone repeatedly,
followed by 8Receiver.
Tip
• The corresponding trigger output goes low (0 volts).
8Receiver
Muting
VOLq/w
Zone
Input selector buttons