Owner's Manual
Table Of Contents
- Safety Information and Introduction
- Connections
- Turning On & Basic Operations
- Turning On/Off the AV Receiver
- Initial Setup
- Playback
- Playing the Connected Component
- Controlling Contents of USB or Network Devices
- Understanding Icons on the Display
- Playing an iPod/iPhone via USB
- Playing a USB Device
- Listening to vTuner Internet Radio
- Registering Other Internet Radio
- Changing the Icon Layout on the Network Service Screen
- Playing Music Files on a Server (DLNA)
- Remote Playback
- Playing Music Files on a Shared Folder
- Listening to AM/FM Radio
- Playing Audio and Video from Separate Sources
- Using Basic Functions
- Advanced Operations
- Controlling Other Components
- iPod/iPhone Playback via Onkyo Dock
- Controlling Other Components
- Preprogrammed Remote Control Codes
- Looking up for Remote Control Codes
- Entering Remote Control Codes
- Remapping Colored Buttons
- Remote Control Codes for Integra/Onkyo Components Connected via RI
- Resetting the Remote Mode Buttons
- Resetting the Remote Controller
- Controlling Other Components
- Learning Commands
- Using Normal Macros
- Appendix
Appendix
En-101
■ “Monitor Out” set to “Analog”
Video input signals flow through the AV receiver as
shown, with composite video and PC IN (Analog RGB)
sources being upconverted for the component video output.
Use this setting if you connect the AV receiver’s
COMPONENT VIDEO MONITOR OUT to your TV.
The composite video and component video outputs pass
through their respective input signals as they are.
This signal flow also applies when the “Resolution”
setting is set to “Through” (➔ page 55).
Video Signal Flow and the Resolution Setting
When the “Monitor Out” setting is set to “Analog”
(➔ page 55), if the “Resolution” setting is set to anything
other than “Through” (➔ page 55), the video signal flow
will be as shown here, with composite video and PC IN
(Analog RGB) sources being upconverted for the
component video output.
The composite video and component video outputs pass
through their respective analog input signals as they are.
HDMI input signals are not output.
■ Signal Selection
If signals are present at more than one input, the inputs will
be selected automatically in the following order of priority:
HDMI, component video, composite video.
However, for component video only, regardless of whether
a component video signal is actually present, if a
component video input is assigned to the input selector,
that component video input will be selected. And if no
component video input is assigned to the input selector,
this will be interpreted as no component video signal being
present.
In the Signal Selection Example shown below, video
signals are present at both the HDMI and composite video
inputs. However, the HDMI signal is automatically
selected as the source and the video is output by the HDMI
output.
IN
MONITOR OUT
*
1
AV receiver
Composite
Composite Component
Video Signal Flow Chart
HDMI
HDMI
TV, projector, etc
Blu-ray Disc/DVD player, etc.
Component
PC IN
(Analog RGB)
*1
For details, refer to “Video Resolution Chart”
(➔ page 103).
IN
MONITOR OUT
IN
MONITOR OUT
AV receiver
Composite
Composite Component
Video Signal Flow Chart
HDMI
HDMI
TV, projector, etc
Blu-ray Disc/DVD player, etc.
Component
PC IN
(Analog RGB)
IN
MONITOR OUT
Blu-ray Disc/DVD player, etc.
AV receiver
TV, projector, etc.
Composite
Composite
Component
Component
Signal Selection Example
HDMI
HDMI