Owner's Manual
Table Of Contents
- Safety Information and Introduction
- Connections
- Turning On & Basic Operations
- Turning On/Off the AV Receiver
- Initial Setup
- Playback
- Playing the Connected Component
- Controlling Contents of USB or Network Devices
- Understanding Icons on the Display
- Playing an iPod/iPhone via USB
- Playing a USB Device
- Listening to vTuner Internet Radio
- Registering Other Internet Radio
- Changing the Icon Layout on the Network Service Screen
- Playing Music Files on a Server (DLNA)
- Remote Playback
- Playing Music Files on a Shared Folder
- Listening to AM/FM Radio
- Playing Audio and Video from Separate Sources
- Using Basic Functions
- Advanced Operations
- Controlling Other Components
- iPod/iPhone Playback via Onkyo Dock
- Controlling Other Components
- Preprogrammed Remote Control Codes
- Looking up for Remote Control Codes
- Entering Remote Control Codes
- Remapping Colored Buttons
- Remote Control Codes for Integra/Onkyo Components Connected via RI
- Resetting the Remote Mode Buttons
- Resetting the Remote Controller
- Controlling Other Components
- Learning Commands
- Using Normal Macros
- Appendix
Connections
En-15
Connecting a Power Amplifier
If you want to use a more powerful power amplifier, you
can use the AV receiver as a preamp. Connect all speaker
outputs to the power amplifier. See the manuals supplied
with your amplifier for details.
SB···Surround Back, FH···Front High, FW···Front Wide
Note
*1
Specify “None” for any channel that you don’t want to output
(➔ page 58).
*2
When connecting to the SB/FH/FW EXT AMP jacks, you
must set the “Preout to External Amplifier” setting
(➔ page 58).
Using Speakers Without Crossover Network
Connecting speakers without crossover network provide a
fine, three-dimensional sound field that extends bass and
treble performance to the fullest extent. When speakers
without crossover network are used, the AV receiver is
able to drive up to a 5.1 speaker system in the main room.
You must enable “Digital Crossover” in “Speaker Type
(Front)” (➔ page 58) and make the settings of “Digital
Processing Crossover Network” (➔ page 62).
Note
• You need to make the setting before connecting the speakers.
L
R
Power amplifier
*1
*2
Important:
• Speakers without crossover network are speakers with no
built-in crossover network.
• With speakers without crossover network, be careful NOT to
connect tweeters and woofers the wrong way around, as this
may damage your speakers.
• With speakers without crossover network, be careful NOT to
set “Speaker Type (Front)” to “Bi-Amp” as this may damage
your speakers. Make sure that this setting is set to “Digital
Crossover”.
• Confirm that your speakers are without crossover network by
referring to your speaker manual.
Woofer (low)
Tweeter (high)
Front right Front left