Owner's Manual
Table Of Contents
- Safety Information and Introduction
- Connections
- Turning On & Basic Operations
- Turning On/Off the AV Receiver
- Initial Setup
- Playback
- Playing the Connected Component
- Controlling Contents of USB or Network Devices
- Understanding Icons on the Display
- Playing an iPod/iPhone via USB
- Playing a USB Device
- Listening to vTuner Internet Radio
- Registering Other Internet Radio
- Changing the Icon Layout on the Network Service Screen
- Playing Music Files on a Server (DLNA)
- Remote Playback
- Playing Music Files on a Shared Folder
- Listening to AM/FM Radio
- Playing Audio and Video from Separate Sources
- Using Basic Functions
- Advanced Operations
- Controlling Other Components
- iPod/iPhone Playback via Onkyo Dock
- Controlling Other Components
- Preprogrammed Remote Control Codes
- Looking up for Remote Control Codes
- Entering Remote Control Codes
- Remapping Colored Buttons
- Remote Control Codes for Integra/Onkyo Components Connected via RI
- Resetting the Remote Mode Buttons
- Resetting the Remote Controller
- Controlling Other Components
- Learning Commands
- Using Normal Macros
- Appendix
Turning On & Basic Operations
En-46
With the sleep timer, you can set the AV receiver to turn
off automatically after a specified period.
You can adjust the brightness of the AV receiver’s display.
You can display various information about the current
input source as follows.
The following information can be typically displayed.
*1
If the input signal is digital, the signal format is displayed.
Information is displayed for about three seconds, then the
previously displayed information reappears.
When you connect an u-capable Integra/Onkyo
component, you must configure the input display so that
u can work properly.
This setting can be done only from the front panel.
Using the Sleep Timer
1
Press Receiver once followed by Sleep repeatedly
to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in 10
minute steps.
The SLEEP indicator lights on the AV receiver’s
display when the sleep timer has been set. The
specified sleep time appears for about 5 seconds, then
the previous display reappears.
Tip
• If you need to cancel the sleep timer, press Sleep
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver sleeps,
press Sleep. Note that if you press again on Sleep as the
time being displayed is 10 minutes or less, the sleep timer
will go off.
Setting the Display Brightness
1
Press Receiver once followed by Dimmer
repeatedly to switch between: normal, dim, or
dimmer brightness.
Tip
• (North American models) Alternatively, you can use
Dimmer on the AV receiver.
Displaying Source Information
1
Press Receiver once followed by Display
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use Display on the AV receiver.
Sampling
frequency
Input source
Signal format
*1
Listening mode
Input signal
resolution
Output resolution
Changing the Input Display
1
Press TV/CD or Game1.
“TV/CD” or “GAME1” appears on the AV receiver’s
display.
2
Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input display.
Note
“
•“DOCK” can be selected for the “TV/CD”, “GAME1”
input selector, but not at the same time.
• Enter the appropriate remote control code before using the
remote controller for the first time (➔ page 85).
TV/CD → DOCK
→
→
TAPE
■ TV/CD:
GAME1 ↔ DOCK■ Game1: