Owner's Manual
Table Of Contents
- Safety Information and Introduction
- Connections
- Turning On & Basic Operations
- Turning On/Off the AV Receiver
- Initial Setup
- Playback
- Playing the Connected Component
- Controlling Contents of USB or Network Devices
- Understanding Icons on the Display
- Playing an iPod/iPhone via USB
- Playing a USB Device
- Listening to vTuner Internet Radio
- Registering Other Internet Radio
- Changing the Icon Layout on the Network Service Screen
- Playing Music Files on a Server (DLNA)
- Remote Playback
- Playing Music Files on a Shared Folder
- Listening to AM/FM Radio
- Playing Audio and Video from Separate Sources
- Using Basic Functions
- Advanced Operations
- Controlling Other Components
- iPod/iPhone Playback via Onkyo Dock
- Controlling Other Components
- Preprogrammed Remote Control Codes
- Looking up for Remote Control Codes
- Entering Remote Control Codes
- Remapping Colored Buttons
- Remote Control Codes for Integra/Onkyo Components Connected via RI
- Resetting the Remote Mode Buttons
- Resetting the Remote Controller
- Controlling Other Components
- Learning Commands
- Using Normal Macros
- Appendix
Advanced Operations
En-53
Note
• This procedure can also be performed on the AV receiver by
using Setup, the cursor and enter (middle) buttons.
• During Audyssey MultEQ
®
XT32 Room Correction and Speaker
Setup, messages, etc., that are displayed on the TV screen will
appear on the AV receiver’s display.
Explanatory Notes
a Main Menu
b Sub Menu
c Setting target
d Setting options (default setting underlined)
Using the Setup Menu (Home)
1
Press Receiver followed by Home.
2
Use e/r to select “Setup”, and then press Enter.
3
Use q/w to select a main menu item, and then press
Enter.
4
Use q/w to select a sub menu item, and then press
Enter.
5
Use q/w to select a setting target, and use e/r to
change the setting.
Press Home to close the menu.
Press Return to return to the previous menu.
Return
Home
Receiver
Enter
q/w/e/r
■ Screen Saver
If there is no video signal on the current input source and
no operation for a specific time (three minutes by
default), a screen saver automatically comes on.
Tip
• The time until the screen saver activates itself can be changed
in the “Screen Saver” setting (➔ page 72).
• The screen will return to its previous state if the AV receiver is
operated.
Main Menu Speaker Setup
Speaker Configuration
■ Subwoofer
` Yes
` No
a
b
d
c
Main Menu
Sub Menu