Owner's Manual

39
Turning On the AV Receiver
Standby/On
On/Standby
Receiver
Standby indicator
Turning On and Standby
Press the [On/Standby] button.
Alternatively, press the remote controller’s [Receiver] button, followed by
the [On/Standby] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
To turn the AV receiver off, press the [On/Standby] button, or press the remote control-
ler’s [On/Standby] button. The AV receiver will enter Standby mode. To prevent any
loud surprises when you turn on the AV receiver, always turn down the volume before
you turn it off.
or
R
emo
t
e
controller
AV
rece
i
ver
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup (Audyssey MultEQ
®
)” on page 48.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 41, “Component Video
Setup” on page 42, or “Digital Input Setup” on page 43 respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see “Changing the Input Display” on page 47.
HDMI
OUT IN
TAPE
CD recorder, MD recorder,
RI Dock