Owner's Manual

Advanced Settings
28
Setting Item Default Value Setting Details
Surround 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
r
"None" can be selected only when "Speaker
Settings" - "Height 1 Speakers Type" or "Speaker
Settings" - "Height 2 Speakers Type" is set to
"Not Use".
Back 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
r
In any of the following cases, this setting will be
set to "None".
– "Surround" is set to "None".
– "Speaker Settings" - "Front Speakers Type" is
set to "Normal“ or "Passive Subwoofer" is set
to "Yes", "Powered Zone 2" is set to "Yes" and
ZONE2 is set to on.
– "Speaker Settings" - "Powered Zone 3" is set
to "Yes", and ZONE 2 and ZONE 3 are set to
on.
r
"Full Band" can be selected only when
"Surround" is set to "Full Band".
Back ch 2ch Select the number of channels of the connected
surround back speaker.
"1ch": When one speaker is connected (Connect to
the BACK L terminal)
"2ch": When two speakers are connected
r
The setting cannot be changed if "Back" is set to
"None".
Setting Item Default Value Setting Details
Wide None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
r
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Surround" is set to
"None".
– "Speaker Settings" - "Front Speakers Type" is
set to "Bi-Amp".
– "Speaker Settings" - "Height 2 Speakers Type"
is set to other than "Not Use".
– "Speaker Settings" - "Powered Zone 2" is set
to "Yes".
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
Height 1 None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
r
The setting is fixed to "None" if "Height 1
Speakers Type" is set to "Not Use".
r
The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
AMP".
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
r
If any type is selected in "Speaker Settings" -
"Height 1 Speakers Type", this setting will be set
to "80Hz(THX)" as default value. In this case, this
setting cannot be set to "None".