Owner's Manual

Advanced Settings
31
Setting Item Default Value Setting Details
Height 2 Right 9.0ft/2.70m Specify the distance between each speaker and the
listening position.
r
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height 2 Speakers Type" is set
to "Not Use".
– "Speaker Settings" - "Front Speakers Type" is set to
"Bi-Amp".
Height 2 Left 9.0ft/2.70m Specify the distance between each speaker and the
listening position.
r
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height 2 Speakers Type" is set
to "Not Use".
– "Speaker Settings" - "Front Speakers Type" is set to
"Bi-Amp".
r
When the speaker is set to "None" in "Speaker Configuration", the settings for "Speaker Distance"
cannot be changed.
r
Default values vary depending on the regions.
Level Calibration
Adjust the level of each speaker with the built-in test tone. Settings are automatically
configured if you use the Automatic Speaker Setup.
Setting Item Default Value Setting Details
Front Left 0.0dB
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired level.
Wide Left 0.0dB Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired level.
r
The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
AMP".
Center 0.0dB
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired level.
Setting Item Default Value Setting Details
Wide Right 0.0dB
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired level.
r
The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
AMP".
Front Right 0.0dB
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired level.
Surround Right 0.0dB Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired level.
Back Right 0.0dB Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired level.
r
The setting is not displayed if "Speaker
Configuration" - "Back" is set to other than
"None" and also "Back ch" is set to other than
"1ch".
r
In the following cases, the setting cannot be
changed:
– "Speaker Settings" - "Powered Zone 3" is set to
"Yes", and ZONE2 and ZONE3 are set to on.
– "Speaker Settings" - "Front Speakers Type" is set
to "Normal“ or "Passive Subwoofer" is set to "Yes",
"Powered Zone 2" is set to "Yes" and ZONE2 is
set to on.
– "Speaker Settings" - "Front Speakers Type" is set
to "Bi-AMP".