Owner's Manual
57
First Time Setup—Continued
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
To use bi-amping or bridging, you must change the
“Speaker Type” setting. For hookup information, see
pages 25–26.
Notes:
• When bridging is used, the AV receiver is able to drive
up to 5.1 speakers in the main room.
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
Speaker Settings
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w] but-
tons to select “2. Speaker
Setup”, and then press [Enter].
The “Speaker Setup” menu appears.
-
TV VOL
--
/
---
10 11 12
D.TUN
+10
0
Clear
456
789
Input Selector
Tape
Tuner
CD
Phono Net/USB
Macro
123
VCRDVD
CDR/MD/Dock
CD
Zone
2
Remote Mode
Dimmer
Tape/AMP
Sleep
Receiver
TV
Net/USB
Cable
VOL
CH
Disc
Album
+
-
Enter
T
o
p
M
e
n
u
M
e
n
u
Display Muting
E
x
i
t
G
u
i
d
e
Prev
CH
R
e
t
u
r
n
S
e
t
u
p
Playlist
RandomRec
SAT
Zone
3
2, 3
1
1, 6
2–
5
If you change these settings, you must run the auto-
matic speaker setup again (see page 60).
Receiver
S
e
t
u
p
Enter
Enter
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
Use the Up and Down [q]/[w] but-
tons to select “1. Speaker Set-
tings”, and then press [Enter].
The “Speaker Settings” menu appears.
4
Use the Up and Down [q]/[w] but-
tons to select “Speaker imped-
ance”, and use the Left and Right
[e]/[r] buttons to select:
4ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [q]/[w] but-
tons to select “Speaker Type,”
and use the Left and Right
[e]/[r] buttons to select:
Normal:
Select this if you’ve connected your
front speakers normally.
Bi-Amp:
Select this if you’ve connected your
front speakers for bi-amped opera-
tion.
BTL:
Select this if you’ve connected your
front speakers for bridged opera-
tion. The BTL indicator will appear
on the display.
6
Press the [Setup] button.
Setup closes.
Enter
Enter
2–1. Speaker Settings
Speaker impedance
Speaker Type
Front
6ohms
Normal
MOVE VALUE RETURN
RETURN
EXIT
SETUP
Enter
Enter
S
e
t
u
p