User's Manual

CHOOSING A BASE UNIT LOCATION
When selecting a location for your base unit,
please observe the following guidelines:
• Choose a location that provides easy access
to an AC power source and telephone jack.
• Do not place the base unit near a sink,
bathtub or shower, or close to heat sources.
• Do not place the base unit near large metal
objects or electronic appliances that may
cause radio interference.
CONNECTING THE BASE UNIT
To connect the base unit:
1. Plug the AC adaptor into the power jack on
the bottom of the base, and then plug the
other end into an electrical outlet (see below).
2. Plug the telephone line cord into the
telephone line jack on the bottom of the base
unit, and then plug the other end into your
phone jack.
BATTERY SETUP
To install the battery in your handset:
1. Open the battery compartment cover located
at the bottom of the handset.
2. Plug the battery connector into the socket.
3. Place battery in the battery compartment.
4. Replace the battery compartment cover by
sliding it into place. (The cover clicks into
place when it is secured).
NOTE: The handset comes with the battery
already installed.
CHARGING HANDSET BATTERIES
You must charge the handset batteries for 15
continuous hours the first time you use them.
When the battery icon in the top right corner on the
LCD screen appears empty, or if you hear a
warning beep during a call, please:
• End the call as soon as possible.
• Charge the handset by putting it back on the
base cradle. (The handset will begin to beep
to indicate that the handset is charging).
LOW BATTERY CHARGING
When the battery is low and has only 15 minutes
of talk time left, the handset will beep a warning
tone and the LCD display will flash “Low Battery”.
When this happens, please end the call as soon
as possible, and put the handset back on the
charger until the battery symbol returns to high
level.
HANDSET RECEPTION
Usually, a loss of reception means you are too far
from the base unit, or there is interference
between the base unit and handset. Make sure to:
• Stay within a range of 300 meters (984 feet)
from the base unit while using the handset.
• Avoid interference such as TV or other
electrical appliances.
NOTE: If your handset is out of range of the base
unit, the range symbol
starts flashing.
HANDSET LCD SYMBOLS
Within range indicator
Flashing when out of range
Ringer is set to OFF
EXT
Line-in-use
Missed call
Battery (5 levels)
Flashing when battery is low
(level 1
)
BASIC TELEPHONE FUNCTIONS
While operating your Cube Phone, if you want to
escape from the menu or the current mode, press
.
NOTE: The following instructions are for the
Phone Mode.
SWITCHING TO PHONE MODE
To change to Phone Mode:
1. Press / , then use or
to select “Goto Phone”.
2. Press
/ .
NOTE: When you enter the Phone Mode, the
telephone icon will appear at the top of
your LCD display.
MAKING A CALL
To make a call, press
to get the dial tone,
and then dial the number. (If you make a mistake,
press
again to cancel the whole number).