User's Manual

Resetting to default

You can reset the phone programming to the initial factory default settings. The

default settings are:

Language English

Area Code - - -

Ringer Tone 1

Tone/Pulse Setting Tone

1. Make sure the phone is OFF (not in TALK mode).

2. Press FLASH/PROG repeatedly until “DEFAULT 1 NO” shows on screen.

3. Press

CID or , or the 1 or 2 keys to select your choice between “1 NO”

and “2 YES” for Default Settings”

4. Press

FLASH/PROG again to conrm. You will hear a conrmation tone.

Receiving a call

When receiving an incoming call, the LED on the handset ashes, and the hand-

set will show caller information. *

* Note: A subscription is required from your local phone company to receive

Caller ID information on your phone. See Caller ID Features, page 16.

1. Press

TALK to answer the call.

Note: If handset is in the base cradle, remove it from base before pressing

the

TALK key. Either handset 1 or handset 2 can answer the call at once.

(for PM5855)

2. Press

TALK to end your call.

Note: If you replace the handset to the base cradle or charger cradle (for

PM5855), the handset automatically hangs up.

BASICS

manual-en-pm5851-re1.indd 12 2006/9/7 19:02:16