User's Manual
19
Deleting all entries
1. Make sure the phone is OFF (not in TALK mode).
2. Use the CID/VOL or keys to display any entry.
3. Press and hold
CH/DEL, until “DELETE ALL?” shows on screen.
4. Press
CH/DEL again to conrm. “NO CALLS” shows on screen.
You can store up to 10 names (up to 15 characters) and numbers (up to 24
digits) in the directory for quick dialing. If a number exceeds 24 digits, you can
program it in parts, and then chain dial the number.
Store a number in the directory
To program a number to memory:
1. Make sure the phone is OFF (not in TALK Mode).
2. Press
MEM key to start the Memory Programming Mode. “MEMO # --”
shows on the screen.
3. Select the desired memory location (0 – 9) or use the
CID/VOL or
keys to nd an empty memory location.
4. Press the
MEM key again. The screen shows “ENTER NAME”.
5. Use the digit keys to enter the name. The cursor advances 1 space after
each key press. Within 1 second, you can press the same key again to
select another character. If you make a mistake, press
CH/DEL to delete
previous characters one by one.
Key Press 1 2 3 4 5 6 7 8 9
1
st
– 5
th
press A D G J M P T W
2
nd
– 6
th
press
–
B E H K N Q U X
3
rd
– 7
th
press * C F I L O R V Y
4
th
– 8
th
press ! ( ) $ ’ ; S ? Z
6. Press MEM again to save the name. “ENTER TEL NUMBR” shows on
screen.
7. Use the digit keys to enter the desired telephone number. If you make a
mistake, press
CH/DEL to delete previous digits one by one, then enter the
correct digits. If you wish to add a pause, press
PAUSE two times at the
desired location. Be sure to press it twice, or you will enter a # (number sign)
DIRECTORY
manual-en-pm5851-re1.indd 19 2006/9/7 19:02:20