User's Manual
20
and not a pause. Each pause counts as 1 digit in the dialing sequence.
Or you can store redial number in the directory by pressing
REDIAL (Note
If the redial number is longer than 24 digits, it cannot be stored into the
memory.).
8. Press
MEM again to store the number to memory. If you are replacing a
number, “REPLACE MEMO?” shows on screen. Press
MEM again to
conrm, or press *
TONE/EXIT to return to standby mode.
9. To view your directory, press
MEM and use CID/VOL or or the
number (0-9) to scroll.
Replacing a directory entry with a Caller ID entry
Use the same procedure as for storing Caller ID entries in the directory
Changing a stored number
Use the same procedure as for storing a number in the directory
Making calls from the directory
1. Make sure the phone is ON by pressing TALK.
2. Press
MEM.
3. Press the number
(0 - 9) for the desired memory location. The number dials
automatically.
Or:
1. Make sure the phone is OFF (not in TALK mode).
2. Press
MEM.
3. Press the number (0-9) or use CID/VOL or to select the desired
number.
4. Press
TALK, the number will be dialed automatically.
Reviewing and deleting directory contents
1. Make sure the phone is OFF (not in TALK mode).
2. Press
MEM.
3. Use CID/VOL or to scroll through the directory until the desired name/
number is shown, or use the number pad to select a memory location. The
selected telephone number and name show on screen.
4. While the entry is displayed, press
CH/DEL to delete the entry. The screen
shows “DELETE?”
5. Press
CH/DEL again to delete the entry. “DELETED” shows on screen.
manual-en-pm5851-re1.indd 20 2006/9/7 19:02:20