User's Manual
27
4. Press MENU to conrm. Repeat steps 2 and 3 to set the other digits of the
access code. When the four digits are dened, the voice prompt will conrm
the access code set.
5. Press
MENU to conrm and exit to standby mode.
Note: The default remote access code is 0000.
Remotely access the answering machine
1. Dial your number and wait for the answering machine to pick up.
2. While the announcement message is playing, dial # followed by the remote
access code.
3. To listen to your messages, dial the number of the mailbox (1, 2 or 3). For
other remote functions, please refer to the table below.
Function
Play mailbox messages
Play previous message
Stop message
Play next message
Delete current message
Record Memo
Record announcement
Toggle answering machine on or off
Toggle “Announce only” on or off
Go on-hooked to standby
Help desk
Command
Dial 1, 2 or 3, to select and play message
in mailbox 1, 2 or 3.
During message playback, dial 4
During message playback, dial 5 to stop.
During message recording, dial 5 to stop.
During message playback, dial 6
During message playback, dial 7
During remote access standby, dial 8
and then 1, 2 or 3 to record memo in the
corresponding mailbox.
Dial 9 to record announcement. After
recording, the announcement is played
back.
During remote access standby, dial 0
During remote access standby, Dial #
Timeout
Press * after entering the remote access
code
Note: If using a cell phone to remotely access the Digital Answering Machine,
you may need to congure your cell phone’s dial tone duration. Please see I
cannot access the Digital Answering Machine from a remote line page 35.
manual-en-pm5851-re1.indd 27 2006/9/7 19:02:22