User's Manual

IMPORTANT SAFETY INSTRUCTIONS
Some of the following information may not apply to your particular product;
however, when using telephone equipment, basic safety precautions
should always be followed to reduce the risk of fire,electric shock and
injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4. Telephones should not be used while you are in a bathtub, shower or
pool. Immersion of the telephone or handset in water could cause an
electrical shock.
5. Slots and openings in the cabinet back or bottom are provided for ven-
tilation, to protect it from overheating. These openings must not be
blocked or covered. The openings should never be blocked by placing
the product on the bed, sofa, rug, or other similar surface. This product
should not be placed in a built-in installation unless proper ventilation
is provided.
6. This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power
supply to your home, consult your dealer or local power company.
7. Do not allow anything to rest on the power cord. Do not locate this pro-
duct where the cord will be abused by persons walking on it.
8. Do not overload wall outlets and extension cords as this can result in
the risk of fire or electric shock.
9. Never push objects of any kind into this product through cabinet slots
as they may touch dangerous voltage points or short out parts that
could result in a risk of fire or electric shock. Never spill liquid of any
kind on the product.
10.To reduce the risk of electric shock, do not disassemble this product,
but take it to a qualified serviceman when service or repair work is
required. Opening or removing covers may expose you to dangerous
voltages or other risks. Incorrect reassembly can cause electric shock
when the telephone equipment is subsequently used.
11. Do not expose the product to extreme temperatures such as areas
near a hot radiator or stove or in a hot car.
12. Do not place lighted candles, cigarettes, cigars, etc., on the telephone.
13. Never touch uninsulated telephone wires or terminals unless the tele-
phone line has been disconnected at the network interface.
14. Never install or modify telephone wiring during a lightning storm.
15. Never install telephone jacks in wet locations unless the jack is speci-
fically designed for wet locations.
16. Use caution when installing or modifying telephone lines to prevent
electrical shock and/or fire.
17. Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
A. When the power supply cord or plug is damaged or frayed.
B. If the product has been exposed to rain or water.
C. If the product does not operate normally by following the operating
instructions.
D. If the product’s cabinet has been damaged.
E. If the product exhibits a distinct change in performance.
18.Avoid using a telephone (other than a cordless type) during an elec-
trical storm. There may be a remote risk of electric shock from
lightning.
19. Do not use the telephone to report a gas leak in the vicinity of the leak.
20.Do not place this product on an unstable cart, stand or table.
The product may fall, causing serious damage to the product.
21. For servicing or replacement, you can purchase a suitable headset
through service center or retailer shop.
22. Plug the adaptor to the socket-outlet which is nearest the equipment
and shall be easily accessible.
IF YOUR PRODUCT UTILIZES BATTERIES, THE
FOLLOWING ADDITIONAL PRECAUTIONS SHOULD
BE OBSERVED:
CAUTION:
Risk of explosion if battey is replaced by an incorrect type.
1. Use only the type and size battery(ies) specified in the user manual.
2. Do not dispose of the battery(ies) in fire. They may explode.
Check with local codes for possible special disposal instructions.
3. Do not open or mutilate the battery(ies). Released electrolyte is corro-
sive and may cause damage to the eyes or skin. It may be toxic if
swallowed.
4. Exercise care in handling battery(ies) in order not to short out the
battery(ies) with conducting materials such as rings, bracelets, and
keys. The battery(ies) or conductor may overheat and cause burns.
5. Do not attempt to recharge the battery(ies) provided with or identified
for use with this product that are not intended to be recharged. The
battery(ies) may leak corrosive electrolyte or explode.
6. Do not attempt to rejuvenate the battery(ies) provided with or identified
for use with this product by heating them. Sudden release of the
battery(ies) electrolyte may occur causing burns or irritation to eyes or
skin.
7. When replacing battery(ies), all batteries should be replaced at the
same time. Mixing fresh and discharged batteries could increase inter-
nal cell pressure and rupture the discharged battery(ies).
(Applies to products employing more than one separately replaceable
primary battery.)
8. When inserting battery(ies) into this product, the proper polarity or
direction must be observed. Reverse insertion of battery(ies) can
cause charging, and that may result in leakage or explosion.
9. Remove battery(ies) from this product if storing over 30 days because
the battery(ies) could leak and damage the product.
10.Discard “dead” battery(ies) as soon as possible since “dead” batteries
are more likely to leak in a product.
11. Do not store this product, or the battery(ies) provided with or identified
for use with this product, in high-temperature areas.Batteries that are
stored in a freezer or refrigerator for the purpose of extending shelf life
should be protected from condensation during storage and defrosting.
Batteries should be stabilized at room temperature prior to use after
cold storage.
12. If your product uses rechargeable battery(ies), charge the battery(ies)
only in accordance with the instructions and limitation specified in the
User Manual.
SAVE THESE INSTRUCTIONS
Use only with Class 2 power source 9VDC 300mA for base
unit and 9VDC 200mA for charger unit.
Printed in China