User's Manual

Battery setup

1. Remove the battery compartment cover on the handset, insert the battery,

plug the cord into the jack (inside the compartment) and replace the cover.

2. Set the handset

RINGER switch to ON, and place handset in the base.

Slide down the

battery cover

Place the battery

in the slot

Plug the wire into

the jack

Slide up the

battery cover

Connecting the base unit and charging the handset

1. Plug the AC adaptor into the power DC 9V

jack on the back of the base. Plug the other

end into a wall outlet.

2. Set the base on a desk or tabletop and place

one handset in the base unit.

3. Make sure that the

CHARGE/IN USE LED

illuminates.

Connecting the charger and charging the handset (For Multi-

handset version and expansion handset version)

1. Plug the AC adaptor into the power DC 9V

jack on the back of the charger. Plug the

other end into a wall outlet.

2. Place another handset in the charger and

make sure that the

CHARGE LED illuminates.

Note: • Charge your handset at

least 12 hours before plugging into the phone line.

• Charge the handset for 12 continuous hours prior to rst use.

The initial battery charge is important for best performance.

• It is normal for the handset and base to get warm when the

handset is charging in the base.

Caution: Use only the PhoneMate AC adaptor that is supplied with this

phone. Using another AC adaptor may damage the phone.

manual-en-pm5851-re1.indd 7 2006/9/7 19:02:13