User's Manual

• When you press a button from the keypad, you should hear the confirmation

"beep" from the PM5821 or PM5805, and also the tone or pulse (depending on

your dialling method) that actually dials the number. Try dialling more slowly

and ensure you hear both of these sounds. If not try pressing the same

number again.

My handset(s) have static noise

• Try re-registering the handset to the PM5821 base unit as described in the

manual.

TELEPHONE

No dial tone

Check installation:

- Is the base power cord connected to a working outlet?

- Is the telephone line cord connected to the base unit and the wall jack?

• Disconnect the base from the wall jack and connect another phone to the

same jack. If there is no dial tone in the second phone, the problem might be

your wiring or local service.

• Is the handset out of range of the base?

• Make sure the battery is properly charged (12 continuous hours).

• Is the battery pack installed correctly?

• Did the handset beep when you pressed TALK? Did the CHARGE/IN USE

indicator come on? The battery may need to be charged.

Dial tone is OK, but cannot dial out

• Make sure the TONE/PULSE dialing mode is set to TONE or PULSE

according to your phone service.

Handset does not ring

• Make sure the RINGER switch on the handset is turned to ON.

• You may have too many extension phones on your line. Try unplugging

some phones.

• See solutions for No dial tone.

You experience static, noise, or fading in and out

• Change channels.

• Is handset out of range? Move closer to the base.

If you hear 3 short beeps when you press TALK, you are out of range.

• Does the base need to be relocated?

PM5821manual 21mar.p65 2006/5/12, ¤U¤È 05:4925