User's Manual

EN
OPERATING THE BASE UNIT
3. Before screwing the back bracket on to the
remote sensor, you need to reset the sensor
by pressing the reset hole with a blunt stylus,
such as an “unfolded” paper clip.
NOTE: Beside the RESET button on the back of
the remote sensor, there is a switch to select the
channel of the remote sensor.
4. Take the four bolts and screw them back in to
replace the back bracket.
NOTE: Make sure the thin black rubber lining
around the circumference of the batteries lines up
with the crease in the back bracket so water does
not seep in to the sensor if wet.
When it is time to replace the batteries, the low-
battery indicator will show up when the respective
channel is selected. The battery level of the main
unit will be shown on the indoor temperature
display when it is running low.
The individual channel temperatures will be
displayed on the 2
nd
line and the indoor tempera-
ture on the 3
rd
line. The Base Unit will automati-
cally update its readings at about 30-second
intervals.
1. Take a Philips screwdriver and remove the
four screws in the back bracket.
2. Move the black switch to 1, 2 or 3.
3. Take the four bolts and screw them back in to
replace the back bracket.
LOW BATTERY WARNING
If no signals are received, blanks “__
•
__ °C__%“ will
be displayed and the kinetic wave icon will show.
NOTE: Once a channel is assigned to a remote
unit, you can only change it by replacing the
batteries or resetting the unit.
The remote sensor has a retractable table stand,
which when flipped open can support the unit on a
flat surface. Or you can flip close the stand and
mount the unit on a wall using the recessed screw
hole.
This button is only used when the unit is operating
in an unfavorable way or malfunctioning. Insert a
pointed object such as an unfolded paper clip into
the reset hole, then press and hold. All settings
will return to their default values.
The Weather Base Unit displays the weather fore-
cast as well as the outdoor and indoor tem-
perature and relative humidity. You may also set
the alarm to activate, indicating when a certain
temperature or humidity has been reached.
NOTE: On the top line in the Base Unit, the radio
signal should show the signal emitting a radio fre-
quency to the remote sensor.
SETTING A CHANNEL IN REMOTE
SENSOR
14
TABLE STAND OR WALL MOUNT
THE RESET BUTTON
manual-E1.p65 2004/12/10, AM 10:3518