User's Manual

EN
If your weather phone is not working correctly,
check the points here before returning it for repair.
Whatever your problem, you should first check
that:
• You have installed the Base Unit correctly,
and it is plugged into the telephone line and the
main power socket.
• Main power is switched on at the socket.
• You have installed the batteries into the hand-
set.
NEVER attempt any repairs or adjustments
yourself - you could make the problem worse and
invalidate your guarantee.
Problems with making and answering calls:
“I cannot make or answer calls.”
• Try moving the handset closer to the Base
Unit.
• If this doesn’t work, try a different position for
the Base Unit - perhaps higher up if possible.
• The battery charge level may be low - place
the handset in the charging cradle of the Base
Unit to recharge the battery.
• Switch off the power at the main socket, wait
a few seconds and then switch the power back
on, this may solve the problem.
“When I press the TALK button, I cannot make
a call.”
• Please check if the line is already in use by
other handsets registered to the same Base
Unit. The EXT symbol on your handset would
indicate this.
“When I press keys on my handset, digits
appear on the display but I cannot make an
outside call.”
• Try moving the handset closer to the Base
Unit.
• If this doesn’t work, try a different position for
the Base Unit. Make sure it is not near any
electrical equipment, such as another phone,
TV, radio, washing machine, fridge, etc. If
possible, position the Base Unit higher up.
• If any other handsets are registered to the
same Base Unit, make sure they are not
already on a call — you would see the EXT
symbol on your own handset.
• You may need to change the dial type setting
to Pulse dialing if your local telephone ex-
change does not support Tone dialing.
“My call was cut off when I went out of range
of the Base Unit. Now I cannot use my
handset.”
• Please move the handset closer to the Base
Unit.
“I hear a tone while I am using my handset,
and the battery symbol on the display is
“empty”.
• The battery needs to be recharged. Put the
handset into the charger; it will take up to 15
hours to be fully charged.
“I’ve tried recharging the batteries, but I still
get a warning that it is not charged.”
• The batteries probably need to be replaced.
“The handset does not ring when a call comes
in.”
• Check that you have not set the ringing
volumes to “off” (see section Setting the
Ring Tone Volume).
“The Caller Display function is not working”
• Please check if you have subscribed to the
Caller Display service with your network pro-
vider.
“The Caller Display function is working but
the Caller’s Name from the phonebook is not
displayed even if the same telephone number
calls in”
• You need to store the full telephone number
including the STD code into your phonebook
memory.
20
POTENTIAL ISSUES
TROUBLESHOOTING
manual-E1.p65 2004/12/10, AM 10:3624