User's Manual

Installation instruction

Determine an appropriate position for the Reader

and drill two holes for mounting the reader to the

surface (see mullion mounting drawing on page

12). Do not mount the readers less than 20 cm

(7.87 inch) from each other. Make sure that

enough room to connect the cable is allowed.

Protect the cable against sharp edges and any

damage from chaffing.

2) Remove the Terminal Connector 8 pins from the

back of the Reader. Use a small flat head

screwdriver to loosen off all of the terminals. The

end of the cable should be prepared by cutting it

back to expose the wires and each end should be

twisted to eliminate any loose or frayed wires.

3) The wires should then be connected to the Reader

inline with the Connector Assignments. Wire ends

outside the shielding and optional permanent LED

links should be kept as short as possible.

Note: wires at the connector must be as kept as

short as possible: long, unshielded connections

will reduce the sensitivity of the reader. Twist the

power and ground wires together to avoid creating

magnetic fields.

4) After wiring the reader and the Host system the

Reader is ready to be tested. Apply power and

present a Card to the Reader. The green LED

should flash and the buzzer should beep indicating

a read. If the Host system is connected to the red

and green LED inputs these should follow the

functionality of the Host system.