User's Manual

NewsCaster VT2 Installation
M17-0002-01A Rev 0.0 47 User Manual
If the AUX Power option is configured:
• Connect the AUX Power cable to the
AUX DC POWER jack on the RF Head.
Connect the antenna cable between your
antenna and the appropriate “RF OUTPUT”
port: 2 GHz Omni; 2 GHz Directional; 7 GHz
Omni; or 7 GHz Directional. (Refer to
Figure 23)
NSI & Radio Waves Quad Antenna
Polarization Interconnection
Wiring diagrams are provided to assist in
preparing the polarization cable, including
connector pin assignments and recommended
wire sizes.
See Table 12 & Figure 19 for NSI details.
See Table 13 & Figure 20 for RWI details.
A software setting via the LCD interface is
used to select between the two antenna types,
and will be factory configured per the type
specified when the order is placed.
Quickset QPT90 Pan & Tilt Interconnection
The Pan & Tilt platform will handle a
maximum load of 90 lbs, with 0-355° of
rotation and ± 90° of tilt. The unit features
adjustable "limit" switches for rotation and
tilt. The Pan & Tilt is controlled by an
optional joystick, which is connected to the
NEWSCASTER VT2 Control Unit. The
operator is able to set the platform position to
within 1 degree of the desired position. The
Control Unit displays the azimuth and degree
of rotation, as well as the tilt above and below
the horizon.
Nucomm supports two input voltage versions
of the Quickset QPT90, a 12 VDC version and
a 120 VAC version. Table 11 and Figure 18
show the interconnection between both
QPT90 versions and the RF Head. The
interconnection between the Control Unit and
the RF head is different for each version.
QPT90 - 120 VDC
See Table 9 and Figure 17 for details of the
interconnection between the Control Unit and
the RF Head for this Pan/Tilt Motor version.
QPT90 - 12 VDC
See Table 10 and Figure 16 for details of the
interconnection between the Control Unit and
the RF Head for this Pan/Tilt Motor version.