User's Manual

NewsCaster VT2 Operation
M17-0002-01A Rev 0.0 49 User Manual
5. OPERATION
Figure 26: NEWSCASTER VT2 Front Panel Controls and Indicators
5.1 FRONT PANEL OPERATION
The NewsCaster VT2 operating controls and
indicators are shown in Figure 26. Location
numbers provide for cross-reference
between the figure and description.
On each screen, a cursor appears as an
underscore character, and is moved by the
left () or right () arrow keys. When the
cursor is under a desired item, select it by
pressing “ENT” (Enter) and the underscore
becomes a solid box. Use the up () or
down () arrow keys to scroll the available
screens. Refer to Figures 29 & 30). When
the desired setting has been made, press
“ENT” (Enter) to save the entry and put any
change(s) into effect. If “ENT” (Enter) is
not pressed and the keypad is left idle for 15
seconds, the changes are discarded. In a
multi-digit selection, as in sub-carrier
frequency, the boxed "Enter" cursor can be
moved left or right to select other digits.
Figure 27: Menu Buttons
Default Screen
The Default Screen appears after boot-up
and displays the following information:
• The current Channel.
• The Frequency of the channel.
• The Frequency Band of the unit.
• The outgoing signal’s Output
Signal Level in dBm.
CH=7
7,037.500MHz
BAND=6-7G LOW 0.0dBm A
1
4
2
3
5
8
3
12
13
11
10
9
7
6
14