User's Manual

CamPac2 Installation
M13-0003-00A
19
4.0 INSTALLATION
4.1 UNPACKING AND INSPECTION
Unpack and visually inspect the unit for LCD,
connector, or surface area damage. All claims
should be filed with the carrier. Save all
shipping and packing materials for possible
re-use.
4.2 PRE-INSTALLATION CHECK
Connect the CamPac2 output through a 2-
watt, 20-dB attenuator to a spectrum analyzer
to observe the output frequency on the
analyzer display. After connecting a suitable
power source to the unit, turn the unit on. Set
the spectrum analyzer frequency to the
frequency of the channel being observed on
the CamPac2.
4.3 MECHANICAL INSTALLATION
The CamPac2 comes standard with an Anton
Bauer Mounting Bracket Assembly. This
allows the CamPac2 and battery to be quickly
attached or removed from a portable video
camera. This design is ideal for field use.
Mounting the Camera
To mount the CamPac2 unit to a camera, do
the following:
1. Orient the CamPac2 Guide Pins (Figure 2
and 3) so that the antenna connector is
positioned to the top of the CamPac2.
2. Next, place the CamPac2 Guide Pins into
the corresponding camera mounting slots.
(See Figure 2).
3. Slide the CamPac2 onto the mounting
bracket until you hear the thumb-catch
lock. Ensure that there is no play between
the CamPac2 and the camera.
4. Screw the antenna onto the CamPac2.
Ensure that the antenna is secure.
5. Orient the Battery Guide Pins to the
CamPac2.
6. Slide the battery onto the CamPac2 until
you hear the thumb-lock catch. Ensure that
there is no play between the battery and the
CamPac2, (See Figure 3).
7. Connect the desired camera outputs to the
CamPac2.
NOTE: When setting up the CamPac2,
ensure that the Main Menu
selections match the physical
connections.
Figure 1: System Check