User's Manual

CamPac2
M13-0003-00A
2
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
FCC CAUTION
Any change or modification not approved by the party responsible for compliance
could void the user’s authority to operate this device.
This device requires professional installation.
For operation within 5.725 - 5.850 GHz frequency range, the maximum EIRP must be
less than 36 dBm. The qualified antenna types to be used with this device include:
Low Gain Collinear Omni Antenna (4.5dBi or 6 dBi)
Collinear Omni Antenna (8dBi).
For operation within 6,425 to 6,525 MHz and 6,875 to 7,125 MHz range, user(s) must
obtain a license from FCC.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
In order to maintain compliance with the FCC RF exposure guidelines, this device
should be installed and operated with a minimum distance of 20cm between the
radiator, and the body of the operator and/or nearby persons.
CAUTION!
RISK OF ELECTRICAL SHOCK. DO NOT REMOVE COVERS.
 Do not remove any covers.
 Refer servicing to qualified technicians only.
 Disconnect all power before servicing.
 Read and perform all instructions carefully.
 Failure to follow suggested instructions and guidelines may void all
warranties.