User Manual

Revision 1.03
Installation 4-1
4. INSTALLATION
4.1 Unpacking and Inspection
Unpack and visually inspect the unit for
any damage to the LCD, connectors, or
external surface area damage. All
claims should be filed with the carrier.
Save all shipping and packing materials
for possible re-use.
4.2 Pre-Installation Checkout
Nucomm products are shipped fully
tested and calibrated. Should any on-
site testing be desired, the following
setup is recommended: Connect the
ChannelMaster RF output through a 30
watt, 30 dB attenuator to a calibrated
spectrum analyzer. Verify the output
frequency and level correspond to the
transmitter front panel settings within +/-
1dBm.
4.3 Mechanical Installation
The unit ships pre-assembled and re-
quires no mechanical installation other
than cabling.
The base of the unit has one large tripod
screw that is centered on the underside
of the system. A second, smaller tripod
screw towards the rear can also be
used. The base also has six holes for
mounting screws that can be used to
attach the unit from the underside. The
locations of the screw holes are shown
in Figure 4-2.
Figure 4-1: Pre-Installation Checkout Equipment Configuration