User Manual

Revision 1.03
Operation 5-3
Switching to Analog Mode
Set Power Level
The user can toggle between HI or LOW
power by pressing the “HI/LO” Button.
The LCD will then immediately display
the change.
Unit in Low Power Mode
5.2.1 Changing Operating
Frequency
(Requires Frequency Direct Mode. See
Sec. 5.9.1.)
1. Ensure that the Main Menu
screen is displayed on the LCD.
2. Rotate the “Quick-Knob” to
highlight the preset parameter to
be changed.
3. Press the “Quick-Knob” to enter
the selection.
4. Rotate the “Quick-Knob” to adjust
the value of the selection.
5. Press the “Quick-Knob” to enter
the changed value.
6. Rotate the "Quick Knob" until the
digit that needs to be changed is
highlighted.
7. Press "Enter".
8. Change the digit as needed.
9. Press "Enter".
10. Repeat until all digits are correct.
11. When all digits are correct, move
the cursor to the end of the fre-
quency where it says “GHz”.
12. Press "Enter".
When the operating frequency is
changed, the unit goes into standby
while the synthesizer re-tunes to the
new frequency. Transmission resumes
when the new frequency is reached.
Note: If offset channel operation is de-
sired, the user is cautioned to ensure
they have adequate authorized spec-
trum to avoid illegal operation. For ex-
ample, in the US post-Nextel 2 GHz
band plan, which stipulates 12 MHz
channels with 3 MHz offsets, use of 7
MHz or 8 MHz modulation bandwidths
on an offset channel would result in out
of channel emissions and potential ad-
jacent channel interference. Thus, for
this example, 6 MHz modulation band-
width should be used when using offset
channels with Channels 1-7 in the US 2
GHz post-relocation band plan.
5.3 Using Presets
There are 15 user definable Presets.
These Presets are accessed using the
numbered “Preset” Buttons, or
through the “PRE” Button.
The numbered Preset Buttons (1
through 5) are located just below the
LCD. These five numbered preset keys
are provided to rapidly store and recall
custom configurations without requiring
any menu navigation.
There are three banks of Presets: Pa1-
Pa5, Pb1-Pb5, and Pc1-Pc5.
BD=2 GHz
1,999.000MHz
CH=1 0dBm L QPSK PA1