Owner`s manual

Operation
English
- 12 -
Roger Beep Tone Setting
The radio is equipped with a user selectable Roger Beep Tone feature, which enables you to send a Beep Tone at the
end of each transmission after every release of the TALK/CALL Key (5). This will prompt any receiving unit that your
transmission has ended. To enable or disable this function, please proceed as follows :
1. Enter to Menu mode. Advance through the Menu until the Roger Beep icon (C) appears on the LCD display (12).
2. Press the UP Key (11) or DOWN Key (10) to toggle between on (Roger Beep enabled) and oF (Roger Beep
disabled).
3. To exit the Menu, press TALK/CALL key (5).
Call Tone Setting
The radio is equipped with 3 user selectable Call tone melodies. To set the desired Call tone melody, please proceed
as follows :
1. Enter to Menu mode. Advance through the Menu until the CA icon (G) appears on the LCD display (12).
2. Press the UP Key (11) or DOWN Key (10) to toggle between 1~3 choices of Call Tone pattern.
3. To exit the Menu, press TALK/CALL Key (5).
Vibrate Alert Setting
Your radio is equipped with a Vibrate alert for silent operation of the radio. The radio will vibrate when receiving a call
tone transmission instead of emitting a call tone sound. To set the unit at Vibrate alert mode :
1. Enter to Menu mode. Advance through the Menu until the Vibrate Mode icon (B) appears on the LCD display (12).
2. Press the UP Key (11) or DOWN Key (10) to toggle between on (Vibrate Alert enabled) and oF (Vibrate Alert
disabled).
3. To exit the Menu, press TALK/CALL key (5).
Automatic Channel Scanning
This function allows automatic scanning of all channels and programmed memories. To start the automatic scan
function proceed as follows :
1. Press the SCAN/LOCK key (3). Once engaged, the unit will automatically start to rapidly scan the whole
channels of the radio for any activity.
The unit will pause on the first active channel found for about 4-5 seconds, before resuming Scan function. If the
TALK/CALL Key (5) is pressed while on an active chennel, the radio will stop scanning and will resume scanning
after about 14 seconds if no transmission is further received.
If the TALK/CALL Key (5) is pressed while scanning, the radio will return to its original channel.
2. To exit the Scan mode, press again the SCAN/LOCK key (3).
Keypad Lock
To avoid entering unwanted command, press and hold the SCAN/LOCK (3) key for about 5 seconds . The LOCK icon
(A) will appear on the LCD display (12). When the Keylock function is enabled, the UP (11), DOWN (10), SCAN (3)
and MENU (9) keys will be disabled. When the keypad is locked, you will still be able to turn the radio OFF and ON,
Monitor, transmit, receive and send a CALL tone. To unlock the Keypad, press again the SCAN/LOCK (3) key for
about 5 seconds.