User's Manual

WiGig Application User Manual
4 WiGig Application User Manual
The WiGig Connection Utility (CU) is a dedicated application that runs on the NB, lists available docks,
and creates a WiGig link with a selected dock.
The activity button and LEDs are used for connection/disconnection flows on the dock side.
Double click the WiGig CU icon on the desktop to activate the CU application on the NB side unless you
checked the option to launch CU after installation (see Section 3.1 Step 3).
Note: The CU application keeps running from the system tray even if you click the X (close
window) icon on the application. Double-click the CU icon in the system tray to open the
CU again.
Note: The current WiGig CU is not the final version and will be changed in later releases.
4.1 Turn WiGig on
1. Click the grey OFF button to toggle the WiGig on once the CU application is running.
2. The CU scans for available docks and shows a list of docks with the following four statuses:
a. In range – paired: docks that are in range of the NB (for example in the room or cubicle)
and are already paired.
b. In range – not paired: docks that are in range of the NB but did not pair with it.
c. Incompatible: docks that are incompatible (incompatible FW version or non-interoperable
dock) and cannot be paired with this NB.
d. Out of range – paired: docks that were paired before but are currently not in range.
Intel
®
Maple Peak July 2014
User Guide Document Number: 537178-2.1
16 Intel Confidential