User's Manual

adapter may be restricted by the proprietor of the building or responsible representatives of the
applicable organization. Examples of such situations may include:
 Using the wireless adapter on board airplanes, or
 Using the wireless adapter in any other environment where the risk of interference with
other devices or services is perceived or identified as being harmful.
If you are uncertain of the policy that applies to the use of wireless adapters in a specific
organization or environment (an airport, for example), you are encouraged to ask for
authorization to use the adapter before you turn it on.
Regulatory Information
Local Restriction of 802.11a, 802.11b, 802.11g, and 802.11n Radio Usage
The following statement on local restrictions must be published as part of the compliance
documentation for all 802.11a, 802.11b, 802.11g and 802.11n products.
Caution: Due to the fact that the frequencies used by 802.11a, 802.11b, 802.11g and
802.11n wireless LAN devices may not yet be harmonized in all countries, 802.11a,
802.11b, 802.11g and 802.11n products are designed for use only in specific countries,
and are not allowed to be operated in countries other than those of designated use. As a
user of these products, you are responsible for ensuring that the products are used only in
the countries for which they were intended and for verifying that they are configured with
the correct selection of frequency and channel for the country of use. Any deviation from
permissible settings and restrictions in the country of use could be an infringement of
national law and may be punished as such.
USA—Federal Communications Commission (FCC)
This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz and 5.470 to
5.725 GHz frequency ranges. FCC requires this product to be used indoors for the frequency
ranges 5.15 to 5.25 GHz and 5.470 to 5.725 GHz to reduce the potential for harmful interference
to co-channel mobile satellite systems. No configuration controls are provided for this wireless
adapter allowing any change in the frequency of operations outside the FCC grant of
authorization for U.S operation according to Part 15.407 of the FCC rules.
1. This device is intended for OEM integrators only.
2. This device cannot be co-located with any other transmitter unless approved by the FCC.
This device complies with Part 15 of the FCC Rules. Operation of the device is subject to the
following two conditions: