User's Manual




RevisionHistory
Rev. 1.2 ,Feb.2015 30/44
HardwareUser
Guide ,DocumentNumber:N/A
3.1.3 ATCommands
NetworkattachinCallBoxMode,LTEband7.
at+xact=6,2,1,107
at+cgdcont=1,"IP",”www.rohde-schwarz.com”
ThisgivesOKiftheSIMcartisinsertedaccurately.
at+cops=1,2,"00101",7
3.1.4 TheDataApplicationUnit
InstalltheDataApplicationUnit
TheDataApplicationUnit(DAU)packagehastobeinstalledon theCMW.
IncasetheDAUhardwareispopulated,thesoftware(SW)shouldalreadybeinstalledaswell.Check
thisin"SetupSW/HW‐EquipmentInstalledsoftware".
Beforeinstallation:
 TerminatetheCMWBaseSWapplication
–closethewindowwith‘X’
 Inthetaskmanagerkilltheprocess"ComponentEnvironmentServer_2.5.exe".
Installation:
 InstalltheDAU‐SWpackage"SetupCMW_DAU_Support(Release)‐V1.0.15.22"
directlyontheCMW.
 ReboottheCMWdevice.
ActivateDHCPinDataApplicationControl
AftercompletestartupoftheCMWBaseSWapplication,followthestepsbelowtoconfiguretheDAU
forDHCP:

MakesureyourRouterisconnectedtothe"LANDAU"ETH
portatthebacksideoftheCMW.
OpentheSETUPmenuontherightside.
