Datasheet

ManualsBrandsIntel Manualschassis componentsASWTAPECABLE

Intel is a registered trademark of Intel Corporation or its subsidiaries in the United States and other countries.

Intel

Server Chassis SR2300

Tape Drive Cable Kit

Kit Contents

The kit contains the following:

• SCSI cable with integral terminator

• Power cable

What you must purchase separately:

• Intel

Server Chassis SR2300

• SCSI tape drive

Installing Your Tape Drive

1. Observe all the safety precautions in your chassis’ manual.

2. Remove the tape drive from its packaging. Set any jumpers or switches according to

the manufacturer’s instructions.

3. Remove the chassis cover.

4. Disconnect the flex circuit cable from the backplane.

5. Remove the processor duct.

6. Disconnect and remove the fan module.

7. Press the blue tab toward the hot swap drives to release the tape drive carrier.

8. Remove the tape drive carrier from the chassis.

OM1465

Figure 1. Removing the Tape Drive Carrier

Summary of content (4 pages)

PAGE 1
Intel® Server Chassis SR2300 Tape Drive Cable Kit Kit Contents The kit contains the following: • SCSI cable with integral terminator • Power cable What you must purchase separately: • • Intel® Server Chassis SR2300 SCSI tape drive Installing Your Tape Drive 1. Observe all the safety precautions in your chassis’ manual. 2. Remove the tape drive from its packaging. Set any jumpers or switches according to the manufacturer’s instructions. 3. Remove the chassis cover. 4.
PAGE 2
9. Remove the plastic cover from the tape drive carrier. OM14658 Figure 2. Removing the Plastic Cover 10. Position the tape drive in the carrier and secure it with four screws. OM14659 Figure 3.
PAGE 3
11. Connect the power cable to the drive. 12. Connect the SCSI cable to the drive. Note that the SCSI terminator must on the end of the SCSI cable connected to the drive. OM14660 Figure 4. Connecting Cables to the Tape Drive 13. Feed the cables into the chassis. 14. Slide the carrier into the chassis until it latches into place. Make sure that the cables don’t get pinched. OM14661 Figure 5.
PAGE 4
15. Connect the power cable (A) to the connector on the backplane. 16. Connect the SCSI cable (B) to the server board. You may also connect it to a PCI card. If you connect it to the server board or a low profile PCI card, route the cable between the chassis and the fan module as shown. If you connect it to a full height PCI card, route the cable along the bottom of the fan module. A B OM14662 Figure 6. Connecting Cables to the Server Board 17. 18. 19. 20. 4 Install and connect the fan module.