Datasheet

Intel® Xeon® Processor 3500 Series Datasheet Volume 1 79
Thermal Specifications
6 Thermal Specifications
6.1 Package Thermal Specifications
The processor requires a thermal solution to maintain temperatures within its operating
limits. Any attempt to operate the processor outside these operating limits may result
in permanent damage to the processor and potentially other components within the
system. Maintaining the proper thermal environment is key to reliable, long-term
system operation.
A complete solution includes both component and system level thermal management
features. Component level thermal solutions can include active or passive heatsinks
attached to the processor integrated heat spreader (IHS).
This section provides data necessary for developing a complete thermal solution. For
more information on designing a component level thermal solution, refer to the
appropriate processor Thermal and Mechanical Design Guidelines (see Section 1.2).
6.1.1 Thermal Specifications
The processor thermal specification uses the on-die Digital Thermal Sensor (DTS) value
reported via the PECI interface for all processor temperature measurements. The DTS
is a factory calibrated, analog to digital thermal sensor. As a result it will no longer be
necessary to measure the processors case temperature. Consequently, there will be no
need for a Thermal Profile specification defining the relationship between the
processors T
CASE
and power dissipation.
Note: Unless otherwise specified, the term “DTS” refers to the DTS value returned by from
the PECI interface gettemp command.
Note: A thermal solution that was verified compliant to the processor case temperature
thermal profile at the customer defined boundary conditions is expected to be
compliant with this update. No redesign of the thermal solution should be necessary. A
fan speed control algorithms that was compliant to the previous thermal requirements
is also expected to be compliant with this specification. The fan speed control algorithm
can be updated to utilize the additional information to optimize acoustics.
To allow the optimal operation and long-term reliability of Intel processor-based
systems, the processor thermal solution must deliver the specified thermal solution
performance in response to the DTS sensor value. The thermal solution performance
will be measured using a Thermal Test Vehicle (TTV). See Tabl e 6 - 1 and Figure 6-1 for
the TTV thermal profile and Tab le 6 - 3 for the required thermal solution performance
table when DTS values are greater than T
CONTROL
. Thermal solutions not designed to
provide this level of thermal capability may affect the long-term reliability of the
processor and system. When the DTS value is less than Tcontrol the thermal solution
performance is not defined and the fans may be slowed down. This is unchanged from
the prior specification. For more details on thermal solution design, refer to the
appropriate processor Thermal and Mechanical Design Guidelines (see Section 1.2).
The processors implement a methodology for managing processor temperatures, which
is intended to support acoustic noise reduction through fan speed control and to assure
processor reliability. Selection of the appropriate fan speed is based on the relative
temperature data reported by the processor’s Digital Temperature Sensor (DTS). The
DTS can be read via the Platform Environment Control Interface (PECI) as described in