Product Data Sheet / Brochure

Intel® NUC 11 Compute Element Product Specification
19
CAUTION
It is strongly recommended to make sure that the carrier board power source is disconnected
before installing or removing the Intel® NUC 11 Compute Element into the carrier board connector.
Installing or removing the Intel® NUC 11 Compute Element while a power source is connected to
the carrier board may cause damage to the Intel® NUC 11 Compute Element, operating system
corruption, create a no boot condition or result in data loss.
2.5 Antenna Connection
The NUC 11 Compute Element wireless module does not have any antennas connected. For
wireless and Bluetooth operation appropriate antennas will be required. Depending on the
enclosure design internal or external antennas can be supported. Figure 6 shows the location of
the two antenna connectors on the Mylar side.
Figure 6. Location of the Antenna Connectors
The wireless module uses a standard 2x2 mm size RF micro coaxial receptacle (connector) with an
outer diameter of 1.5 mm as defined in the PCI-E M.2 Specification. Specific plugs should be
selected to suit the assembly allowable mating height and cable diameter. Refer to the PCI-E M.2
Specification for the minimum requirements of the compatible RF connectors and mating plugs.
 Receptacle physical outline is 2mm x 2mm x 0.6mm
 Receptacle outer diameter is 1.5mm