user manual

9
INSTALLATIONS
2.1 System Installation
2.1.1 CPU Installation (IP-4MTS6B series)
Carefully follow the steps below in order to install the CPU:
1. Check and confirm that you are going to install correctly CPU type and
pin numbers (figure 3).
2. Take the screwdriver and releasing screw-nut of the socket 479.
3. Rotate mark of screw-nut to face the “OPEN”.
4. Align the pins of the CPU against the pinholes of the socket 479. Be
sure to pay attention to the orientation of the CPU.
Figure 3: CPU Socket
5. Push down the CPU into the socket 479.
6. Rotate mark of screw-nut to face the “CLOSED”.
7. Place the CPU cooling fan atop the CPU surface.
8. Push down the opposite side of the ZIF clip and hook it.
9. Connect the cooling fan cable to the socket. Be careful not to place the
cable on the CPU cooling fan.
SECTION 2
OPEN
CLOSED
Screw Nut