user manual

Installations

Removing a CPU:

1. Before removing the CPU, turn off the IP-4MTS6B series power; then

wait for about 20 minutes until the heat radiation plate of the cooling fan

and the CPU cools down.

2. Rotate mark of screw-nut to face the “OPEN”.

3. To remove the CPU.

Note: The CPU and the heat radiation plate are hot. They may cause

burns.

To remove the CPU, reverse the installation steps.

2.1.2 Heat Sink Installation

Make sure that good contact is made between the processors and the

heat sinks & fan. Insufficient contact, incorrect types of heat sinks, fans, or

thermal compound used or improper amount of thermal compound applied

on the CPU die can cause the processors to overheat, which may crash the

system.

Figure 4: Heat Sink Installation