user manual

Award BIOS Setup
52
Power On Function: Options Password, Hot KET, Any KEY, BUTTON and
Keyboard 98.
You can use this item to select operating Power On the system.
KB Power ON Password: Option Enter
You can set password to limit operating KB Power On system.
Hot Key Power ON: Options Ctrl+F1 ~ Ctrl+F12
You can use this item to select operating Hot Key to Power On system.
Onboard FDC Controller:
Select “Enabled” if your system has a floppy disk controller (FDC) installed
on the system board and you wish to use it. If you install and-in FDC or the
system has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Serial Port 1 / Port 2:
Select an address and corresponding interrupt for the first and second serial
ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled and
Auto.
UART Mode Select:
This item allows you to select an operating mode for the second serial port.
The choice: IrDA, ASKIR and Normal.
RxD, TxD Active:
This item allows you to select the correct setting of receive and transmit
signals from your IR port.
The Choice: “Hi, Hi”, “Lo, Lo”, “Lo, Hi” and “Hi, Lo”.
IR Transmission Delay:
This item allows you to enable/disable IR transmission delay.
The choice: Enabled, Disabled.
UR2 Duplex Mode:
This item allows you to select the IR half / full duplex function.
The choice: Half, Full.