WHC report

Errata and Contingencies
Operating System
Failing Test
Expiry Date
ID
Number
Type
Error Description
Windows 8 64-bit
USB Exposed
Port System
Test
9/30/2013 1435
AutoTriage
The USB Exposed Port Controller Test is known to fail
without logs in certain configurations using the xHCI
Controller on this system. Please right-click the failed
task to review the Error information. If the task failed
with ExitCode c0000374, a manual erratum might
apply. Before using the manual erratum, it is necessary
to review the PortMappingFinder.wtl log for the Port
Mapping Tool task. If the log contains any 'No
companion port for SuperSpeed port' errors, please
contact the xHCI Controller vendor for a firmware
update and do not attempt to use the manual erratum.
If there are no errors, but there is a 'Couldn't get
connector properties for hub' message, please use
Manual Errata 1435 in a Readme form. The erratum will
only be honored if this AutoTriage filter applies to the
Run Test task.
Windows 8 64-bit
UAA Test
(System)
3/31/2014 1039
Errata
Input Payload should be 0x1d, but is instead 0x0. This is
being requested as a change to the HDAudio spec
Windows 8 64-bit
UAA Test
(System)
10/1/2013 244
Errata
Section 3.3.14 of the Intel High Definition Audio
specification mandates a reset value of 0 for the
Interrupt Control register on HD Audio controllers.
Windows 8 64-bit
UAA Test
(System)
7/1/2014 354
Errata
The FIFO size for Input and Output Stream Descriptors
should be read only
Windows 8 64-bit
USB3
Termination
10/1/2013 1407
Errata
The USB3 Termination test may fail to find the USB 3.0
(Super Speed) device if the system's USB ports are not
numbered contiguously. While nearly all systems have
contingous USB port numbers, it is not technically
required. If this filter allows the FindUsb3Device task to
pass, then HCK Errata ID 1407 can be used in a Readme
form to overturn the remaining cancelled tasks.
Windows 8 64-bit
xHCI Debug
Capability
Compliance
(Logo)
7/31/2014 316
Contingency
The XHCI Debug Capability Compliance Test will fail
XHCI controllers that do not provide the debug
capability registers.