PLMP Report

Systems
PCI/PCI-X Bridges. Assertion 13A41D3E-2576-41DC-A67C-
525DA3637CEA This failure is acceptable because this is a PCIe 1.1
feature and the WLP requires compliance with only PCIe 1.0a.
Windows 7
Windows 7 64-bit
PCI
Hardware
Compliance
Test For
Systems
6/1/2011
1241
Erratum
This happens because the PCI Compliance test assumes that if the
Data Link Layer Link Active Reporting Capable bit in the Link
Capabilities register for a given PCIe port is set then that indicates
that the Data Link Layer Link Active bit will also be set. This is an
incorrect assumption because the Data Link Link Layer Link Active bit
can be reset when there is no device below the port. This assertion
needs to be removed from the PCIHCT. The current architecture of
the PCIHCT prevents it from knowing whether devices exist below a
bridge/port.
Windows 7
Windows 7 64-bit
Class Driver
AC3 Test –
Win7
(System)
6/30/2025
1256
Erratum
Run AC3 test on a system with the Microsoft HD Audio class driver
installed. Expected results: All AC3 kernel streaming data ranges
should advertise MinimumBitsPerSample = 16 and
MaximumBitsPerSample = 16. Actual results: HD Audio class driver
sometimes advertises MaximumBitsPerSample = 24.
Windows 7
Windows 7 64-bit
Graphis
HDMI
System
Test
(Manual)
6/01/2011
1717
Erratum
GraphicsHDMITest: should ignore pin widgets that have "Port
Connectivity" set to "No Physical Connection"
Windows 7
Windows 7 64-bit
Graphis
HDMI
System
Test
(Manual)
6/01/2011
1945
Erratum
Failure is due to the ELDv2 PortId not matching the graphics adapter
LUID. This cannot be enforced currently. In the future, video drivers
will be required to program the ELDv2 PortId with either, The
AdapterLUID for the corresponding display adapter -OR- 0
Windows 7
Windows 7 64-bit
Graphis
HDMI
System
Test
(Manual)
12/31/2011
1666
Erratum
graphics-hdmi-test-intel-two-of-three
Windows 7
Windows 7 64-bit
UAA Test -
Win7
(System)
1/31/2011
1300
Erratum
HD Audio pin configuration document calls out setting Port
Connectivity to No Connection as the way to turn a pin off in a
particular system. UAA Test incorrectly tests such pins.
Windows 7
Windows 7 64-bit
UAA Test -
Win7
(System)
2/28/2011
1288
Erratum
Preview Filter - Encoded Packet Type: The Intel HD Audio DCN 35-A,
HDMI/High Bit Rate, repurposes bits 0 and 1 of the Pin Widget
Control verb to be the Encoded Packet Type (for example, "native" or
"high bit rate.) See section 7.3.3.13 of the DCN for further
information: The codec is expected to perform validation on EPT
values set in this fashion. From the DCN: If the value written to this
control does not correspond to a supported value as defined in the
Pin Capabilities parameter, the control must either retain the
previous value or take the value of 00, which will select the default
native audio packet type.
Windows 7
Windows 7 64-bit
UAA Test -
Win7
(System)
12/31/2011
1670
Erratum
HDMI audio devices are backed by video pipes; if a graphics
subsystem exposes three output ports, but only has two video pipes,
it is not possible to get all three HDMI audio endpoints "active"
simultaneously.
Windows 7
Windows 7 64-bit
UAA Test -
Vista or
Server08
(System)
6/1/2015
513
Erratum
UAA Test requires the Traffic Priority bit to be read/write - however
there are two specs that apply, and they conflict. One says the bit
must be read/write, the other says it must be read-only. Contact has
been made with the author of both specs (Intel) but until this point is
clarified we cannot fail submissions containing this test failure.